A single drip seems like nothing. But according to the US Environmental Protection Agency (EPA), a tap that drips once a second wastes more than 3,000 US gallons a year, around 11,000 litres. That is enough water for more than 150 showers.

How much water does a leaky tap waste?
About 3,000 US gallons (11,000 litres) a year at one drip per second.
The figure comes from the EPA's WaterSense programme. Faster drips waste more, and other small leaks add up too: a showerhead dripping ten times a minute wastes more than 500 gallons (about 1,900 litres) a year.
The bigger picture
The EPA estimates that leaks in the average American home waste more than 9,300 gallons, about 35,000 litres, every year. Across the US, household leaks waste nearly a trillion gallons annually. About 9 per cent of homes have leaks that waste 50 gallons or more a day.
The biggest culprit is often not the tap but the toilet. A worn flapper or valve can let water trickle silently into the bowl all day and night.
How to check for leaks
- Toilets: put a few drops of food colouring in the cistern and wait ten minutes without flushing. If colour appears in the bowl, it is leaking.
- Your meter: if you have a water meter, take a reading, use no water for a couple of hours, then read it again. If it has moved, there is a leak somewhere.
- Taps and showers: look and listen for drips, and check under sinks for damp.
How to fix a dripping tap
Most dripping taps are caused by a worn washer, O-ring or cartridge, cheap parts that many people can replace themselves after turning off the water supply to the tap. If you are not confident, a plumber can usually do it quickly.
The EPA says fixing simple leaks can cut a household's water bill by about 10 per cent. If your water is metered, that saving comes straight back to you. Either way, the water stays in rivers and reservoirs where it belongs.














Leave a reply